It wouldn't go over 40mph so I turned off the main road into a neighborhood where it continued to not go any faster. I had to go up a small hill to get to a safe place to stop and over the hill, the max speed was 20mph. Once I reached the neighborhood and stopped, the van seemed to shake a little and I turned it off. It won't restart. First, locate the key slot and insert your key. Turn the key to the “on” position and wait 10 minutes for the immobiliser to reset. If this doesn’t work, disconnect the battery for 30 minutes and then reconnect it. Keep in mind that common mistakes include not waiting long enough and not following the correct steps. To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to confirm the digit and resume, replicate the procedure until you have entered the entire code. This should allow your Bmw Serie 3 E92 to start without having to remove the With a master passkey III key (Black), turn ON the ignition, with the engine OFF. Observe the Security telltale, after approximately 10 minutes the telltale will turn off. Turn OFF the ignition, and wait 5 seconds. Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes. It's the same ECU internally. The software is different and you'll have access to it all with your kit. The US map just disables the immobilizer input so the software doesn't look for it. The first thing you're going to do is read your ECU binary file and save it as a backup. That will never change. Vay Tiền Trả Góp Theo Tháng Chỉ Cần Cmnd Hỗ Trợ Nợ Xấu.

how do i disable immobilizer